Give Your Factory N55 / B58 Exhaust An Attitude Adjustment
These 3.5" slip-on exhaust tips are the perfect choice for easily dressing up your exhaust outlets. Made from stainless steel and equipped pressure clips so they go on easily and stay in place just like the factory tips. No ugly screws or clamps for a clean appearance. These exhaust tips are sure give your factory exhaust a grand look without spending the big bucks for a complete system. Not for use with M-Performance exhaust systems.
*F chassis M135 and M235 models will need to check your alignment pin before ordering. If your alignment pin is not straight up and down you can only get straight cut tips. Some early build M135 and M235 have an alignment pin that is rotated inward 45º, unlike the straight up and down alignment pin of the 335 and 435.
To install (See video below) remove your factory tips by pounding outward on the lower part of the tip with either a rubber mallet or a hammer. A small piece of wood can also be used between the hammer and the exhaust tip edge. This is done from under the rear of the car. Small medium taps will start the factory tip sliding off the actual exhaust pipe. Secure the tip before it comes off the end of the pipe with your hand. Make sure to keep it straight to not damage the inner spring clips. The cutout must be facing straight or at 45º depending on where your alignment dowell is. Slide the BMS slip-on exhaust tip straight over the factory exhaust pipe. Carefully push the tip straight on until it stops. The tips should completly hide the pipe edge. You may want to cover the edge of the tip with a folded towell and lightly pound with a rubber mallet. See Video Below.
BMS F Chassis 3.5" Slip-On N55 & B58 Exhaust Tips (Pair) Not for use with M-Performance exhaust systems.
$99.00 pair Worldwide Shipping Available.
Estimate Shipping by adding to cart and entering in your ZIP code or country.